About Enigma Semi-Full EASY
Enigma Semi-Full EASY mode exclusive operation application.
This application is for Enigma Semi-Full only. It can not be used for the conventional ENIGMA & FirePlus series.
This application is only for EASY mode which can adjust the ignition time. There is a dedicated application in PRO mode that can set the ignition time.
This application can be downloaded for free. When it is free, you can connect with all Enigma Semi-Full, but only the tachometer screen is displayed. (Only tachometer and TPS are displayed).
In order to set various functions of Enigma Semi-Full, you need to purchase the model data corresponding to Enigma Semi-Full you have from the model selection screen.
When purchasing and selecting model data, the following functions can be used.
– Preset a data combined. Preset data can be easily written to Enigma Semi-Full.
– + 20 / – 20 degree spark advance / delay angle can be adjusted for each engine rotation / throttle position. It is also possible to adjust the dwell time.
– The fuel injection amount can be set for each engine rotation / throttle position.
– Fuel correction at idling can be performed.
– Startability and idling stabilization correction function when using a big injector. (Only for compatible models)
– Adjustment of fuel injection time by engine temperature and intake air temperature is possible.
– It is possible to set injection timing at each rotation speed.
– Various maps can be displayed in 3D graph.
– Two maps can be put inside Enigma Semi-Full, and it can be switched with an external switch.
– In real time, you can display tachometer, throttle opening monitor, injector opening / closing rate, oil / water · engine temperature (depending on model),Voltage (Applicable models only).
– Display the current engine speed and throttle position in real time in the fuel & ignition adjust map.
– Revolution Limit can be set .
– Pit-in limit can be set (Applicable model only)
– Digital acceleration pump can be set.
– It is possible to correct the TPS sensor according to the actual machine.
– You can make several fuel data and save it, you can change it immediately when you need it.
– It corresponds to Japanese and English.
Note You can not connect to some terminals manufactured by Fujitsu or not made in Japan’s due to problems on the terminal side. Please note that you purchase. (You can check whether you can connect with your Android terminal before purchasing model data.)
Pairing setup is required before connecting. When pairing and when connecting for the first time after pairing, keep the distance to Enigma Semi-Full as close as possible to within 30 cm.
There is no direct linkage function of data with other Androrid terminal, PC version or iOS version. Migrate the data via Enigma Semi-Full.
Refunds on model add-ins purchased in in-app billing are not accepted basically.
Please be careful that there are no mistakes in model.
This application contains deliverables distributed under license of Apache License, Version 2.0.
Additional App Information
-
Category:
-
Latest Version:4.21.00
-
Released on:Feb 7, 2019
-
Developed by:DILTS-JAPAN
-
Requires Android:Android 4.0+
-
Available on:
-
Report: